The basic setting the throttle body

 1, the basic configuration elements:

 Turn the ignition switch, throttle control unit can be the engine control unit and adaptive.

 2, the basic setup process:

 Basic settings for throttle, throttle regulator into the emergency operation in the maximum position to the minimum position, the engine control unit through the adaptive learning throttle control unit to stop and throttle position potentiometer comparison with the throttle control sensor the curve.

 3, the following circumstances must be adaptive:

 1) power outages

 2) removable throttle control unit

 3) Replace the throttle control unit

 4) the replacement of the engine

 5) Replace the engine control unit

 4, the basic set conditions:

 1) ECU fault code stored no

 2) The battery voltage is not less than 11.5V

 3) Turn off all accessories

 4) The throttle body should be in idle position

 5, the basic set methods and procedures:

 Turn the ignition switch, but do not start the engine

 Well-informed car connection

 Select the [engine systems] → select → read the fault code fault code stored no confirmation

 Select [System Basic adjustment]

 Enter the channel number [060] or [098] and some models in [001]

 6, when the screen display area 4 shows the ADP OK (adaptive normal), that is the basic setup is complete, press the "Exit" button to complete the setup.

 7, if the basic set interrupt control unit or an error may be due to the following reasons:

 1) throttle body does not meet the idle stop point (carbon or zip to adjust the throttle right)

 2) The battery voltage is too low

 3) damage to the wire throttle control unit or

 4) Throttle committed Card

 5) In the adaptive process of starting the engine, or step on the accelerator pedal

 8, after the failure to interrupt fault stored in memory, "17967" or "17973", next time you turn the ignition switch is automatically re-basic settings.